domains / families / devops / jetson-customize-fan

jetson-customize-fan

separate

Use when you need to add, remove, edit, list, or change the boot default of an nvfancontrol fan profile on a Jetson/Tegra (Orin, Thor) target. Triggers: edit fan profile, tune fan curve.

When to use

• Edit the per-board nvfancontrol configuration so the device boots with the desired fan curve / control mode / governor / default profile. BSP-side only — all writes land in the overlay tracker, the upstream `bsp_image` copy is read-only. T…

When not to use

• BSP-side scope only — this skill never touches a running target's
• Edits land in the overlay copy under `<source.root_path>` only;
• Curve tuples must reflect characterised thermal-acoustic data for
• Propagation across sibling carriers (same module SKU) is partial
• Curve point limits are family-specific; copy verbatim from existing

Skill page

Source